Save space and get even more use out of your power rack by attaching a Vertical Mount Barbell Holder on the front or back. Use this barbell holder to keep your gym tidy.
Fits 2.3″ x 2.3″ uprights with 5/8″ holes only.
Save space and get even more use out of your power rack by attaching a Vertical Mount Barbell Holder on the front or back. Use this barbell holder to keep your gym tidy.
Fits 2.3″ x 2.3″ uprights with 5/8″ holes only.
$29.99
In Stock
-
The vertical barbell holder is an easy, cheap win for your home gym, especially if you have more than one bar.
Weight | 1.4kg/3lbs |
Length | 120.7mm/4.75" |
Width | 60mm/2.4" |
Height | 222.3mm/8.75" |
Inner Sleeve Diameter | 52mm/2.05" |
Inner Sleeve Lining | UHMW plastic (top 2" only) |
Outer Coating | Black Powder Coat |
Max Capacity | 100kg/220lbs |
Warranty | Limited Lifetime Warranty |
IMPORTANT: The Vertical Barbell Holder is designed to fit perfectly with our Bells of Steel upright tubing dimensions of 2.3” x 2.3” (60mm x 60mm) and ⅝” holes.
If your ceiling is less than 9 feet high, you may find using the Barbell Holder challenging with a standard barbell — please keep this in mind prior to purchasing.
The vertical barbell holder has a 52mm/2.05″ inner diameter and its dimensions are: 120.7mm/4.75″ length, 60mm/2.4″ width, and 222.3mm/8.75″ height.
The vertical barbell holder weighs 1.4kg/3lbs.
The vertical barbell holder has a black powder coating on the outside.
Yes, the top 2” inside the vertical barbell holder has a UHMW plastic lining to help protect your bar from scuffs.
The vertical barbell holder should fit on any rack that has ⅝” holes and either 1” or 2” of vertical spacing between holes.
With low ceilings, you should mount the vertical barbell holder as close to the floor as you can. In rare cases, it might only be suitable for a shorter bar like our Women’s Weightlifting Bar or 47” EZ Curl Bar.
Only barbells with a sleeve diameter of 52mm or less will fit. However, Olympic barbells with a 50mm/2” sleeve diameter will have the best fit in the vertical barbell holder.
In the box, you’ll find the following pieces: barbell holder, two (2) bolts, washers and nuts.
To assemble the vertical barbell holder, you’ll need:
• 15mm box end wrench
• 15mm socket wrench or adjustable wrench
Covered under our Limited Lifetime Warranty guarantees that the Barbell Holder will not break under normal use, and protects against defects in material, function and workmanship.